PHILIPS PUS9010 (IPS) vs Sony BRAVIA 2 II (S25M2)

In the Philips PUS9010 version with an IPS panel, the HDR brightness sadly performs worse than in the previously tested 55-inch variant with a VA panel. The difference reaches about 100 nits, which is noticeably significant given the relatively low values. While the VA version could exceed 500 nits, here the maximum brightness reaches around 400 nits. This level still allows for watching movies and series in HDR, especially on streaming platforms, but the effects are clearly more subdued. Bright elements don't have the same impact, and scenes requiring high luminance are less impressive. On the plus side, the coverage of the DCI-P3 colour gamut is commendable. The IPS version offers about 91%, which is roughly 5% more than the variant with a VA panel. This translates into slightly better colour saturation in HDR content, despite the lower brightness. Colours can appear more vivid and cohesive, especially in colourful scenes.

Sony Bravia 2 II isn't a particularly bright TV and unfortunately that's immediately obvious in HDR. In our measurements brightness stayed around 300 to 330 nits, which is far too low for the brightest parts of the image to look truly impactful. In practice HDR here doesn't differ that much from regular SDR. Bright highlights, the sun or lamps are of course visible, but they lack the intensity you'd expect from HDR content. The Bravia 2 II is therefore much better suited to standard SDR material, where its limited brightness will be least noticeable.

Colour gamut coverage

The Sony Bravia 2 II also doesn't impress when it comes to colour. The TV doesn't use any extra gamut-expanding filter, such as the quantum dots found in QLED sets or a PFS phosphor layer. In our measurements it covered about 78% of the DCI-P3 gamut and roughly 57% of the very wide BT.2020. That's definitely too little to deliver truly saturated colours in HDR material. More intense reds, greens or turquoises will simply be less striking than on TVs with an expanded colour gamut. The Bravia 2 II is much better matched to the standard Rec.709 gamut used for films, series and SDR broadcast.

We evaluated colour reproduction, as always, on factory settings, focusing on the movie mode, which in the case of Philips usually offers the best starting point. This is also a good moment to show how much the same model of TV can vary depending on the panel used. Looking at the white balance, the overall tendency remains similar to the version with the VA panel. There is still excessive red in the whites, however, in the tested unit with the IPS panel, there are also losses in the blue channel. As a result, the picture has a slightly different colour character, which is well illustrated in the comparative materials. This is a very good example showing why ready-made settings downloaded from the internet do not always work even within the same model.

However, returning to the assessment itself, this unit performs quite well, especially in SDR content. Colour tests show correct saturation and colour consistency, without glaring errors that could hinder everyday viewing. In HDR materials, it is possible to notice slight losses in reds, but these are not flaws that completely spoil the image perception. The biggest limitations do not stem directly from the colours, but rather from the whites and blacks. The use of an IPS panel and slightly lowered gamma means that the image is slightly boosted in brightness, and weak blacks further affect perceived contrast. This makes everything look brighter, but at the same time, it lacks depth, especially during evening viewing.

The out-of-the-box colour reproduction in Kino mode was really quite good, at least for ordinary SDR material. The Bravia 2 II had a slight tendency to boost reds, which made some colours lean a bit warmer, at times with a faint pinkish tint. That wasn't a major fault and during normal viewing the picture still looked fairly natural. There was a bit more going on with image brightness. Looking at the gamma curve, Sony doesn't stick perfectly to the reference value. The darkest areas are slightly lifted, while as brightness increases the gamma gradually rises and a large part of the image becomes darker than it should. However, the difference isn't big enough to seriously bother during everyday watching. Overall, SDR straight out of the box performs quite decently.

The situation is much worse in HDR. We've already mentioned the limited colour gamut, but on top of that the Bravia 2 II quite aggressively manipulates image brightness. The EOTF curve sits below the reference for much of the range, which means the TV renders most mid and brighter parts of the scene darker than the source material intends. Only towards the very end of the range does the curve flatten out, as the panel reaches the limits of its capabilities. Combined with a peak brightness of around 300 nits, this gives HDR that not only lacks much punch but can simply look too dark.

After calibration, the picture has been brought to a really reasonable level. The whole thing looks cohesive and natural, and when it comes to colour reproduction, it's hard to definitively say whether we're dealing with a VA or IPS panel. This is a good sign, showing that the television has a solid foundation for further adjustments. The larger colour gamut in this variant is a plus, as it can subtly enhance the depiction of colourful scenes, especially in HDR content. However, this advantage is largely offset by the boosted blacks resulting from the use of an IPS panel. The limited depth of black affects perceived contrast, particularly when watching in a dark room. As a result, despite noticeable improvement post-calibration, the final rating remains the same as that of the variant with a VA panel. Better colours are not able to fully compensate for the weaker blacks.

Calibration did a lot for the Bravia 2 II, especially with SDR content. Above all, we managed to even out the white balance and tidy up the gamma, which now stays much closer to the reference value. As a result, the image no longer has the earlier pink cast, and the brightness across different areas is much better organised. You can also see it in the colour errors, which after calibration dropped to a very low level (with only minor issues in the most saturated reds).

We also partly managed to rein in the Bravia 2 II in HDR, especially in the way the TV handles image brightness. However, there is one thing no calibration can fix: the panel's capabilities. A narrow colour gamut means the TV physically can't reproduce the most saturated colours recorded in HDR content. On top of that, the low contrast of the IPS panel causes darker scenes to be covered in a grey haze, which robs colours of some of their depth. So we can improve how the Bravia 2 II uses its capabilities, but we can't overcome the panel's inherent limitations.

In the Philips PUS9010, we find another iteration of the P5 Perfect Picture image processor, which aims to improve the quality of lower-grade materials. One of the components of this system is a distortion reduction function that smooths tonal transitions. It works effectively and actually reduces visible banding. Unfortunately, it does so quite aggressively. In practice, it can mute details such as material textures or film grain. This is a clear compromise, so we wouldn't particularly recommend it for movie sessions. For more casual content, like YouTube or regular television, it performs much better. The P5 processor also handles lower resolution materials quite well. The image is soft, at times even too soft, but it can easily be corrected using the sharpness slider, adjusting the effect to personal preferences. A positive aspect is also the absence of edge cropping in SD materials, which is still not standard in this class of televisions.

Upscaling on the Bravia 2 II performs quite well and the TV maintains the standard we've come to expect from Sony. Lower-resolution material is sensibly upscaled to 4K, and the image is slightly smoothed without excessive edge sharpening. It's less successful at dealing with content that shows visible compression artefacts. That's down to the "Digital Noise Reduction" function, which on the "High" setting can smooth some ugly banding. The problem is it does so quite aggressively and, along with the imperfections, removes a lot of fine detail, including natural film grain. What's more, when there's more motion on screen its effectiveness drops considerably and the improvement is minimal. For that reason we generally didn't use this feature for everyday viewing.

Philips PUS9010 has a 4K panel with a refresh rate of 144 Hz, which will be appreciated mainly by sports fans and gamers. This is especially noticeable in dynamic scenes where the motion is sharp, and annoying blur is almost non-existent. When it comes to movies (standard 24 fps), Philips offers us a proven set of settings known from its higher series. Two sliders are used to control motion. “Smoothness” allows you to adjust the picture to your liking: at low settings, it maintains a cinematic character, while moving the slider to the right gives us a perfectly smooth, albeit slightly “theatrical” effect. Meanwhile, “Motion Blur Reduction” is a feature designed for sports – it ensures that fast-moving objects do not lose detail and remain clear.

Bravia 2 II uses a 60 Hz panel and, for what it is, handles motion quite well. However, bear in mind it’s an entry-level panel and its limitations are especially noticeable with sports. The TV can’t interpolate 50/60 fps material to a higher refresh rate, so it can’t further improve the sharpness of fast-moving objects. For films and series there’s a conventional motion-smoothing feature that can reduce the judder typical of 24 fps material.

Philips PUS9010 is a solid machine for gaming. It has everything that’s important: VRR, automatic game mode (ALLM), and support for HGiG. The latter is fantastic – it allows you to set HDR in games exactly the way the developers envisioned. The TV handles 120 Hz refresh rates effortlessly at every popular resolution (1080p, 1440p, and 4K). It doesn’t matter if you connect a PS5, Xbox, or a powerful PC – everything runs smoothly and just as it should. Gamers will also appreciate the Game Bar. It’s a quick, clear menu where you can immediately see if the low latency mode is active. This is especially useful when frequently switching between different consoles. The whole experience is enhanced by Ambilight. Evening sessions with this backlighting create a whole different level of atmosphere; the image seems larger, and dynamic scenes are even more impressive. Even if someone isn’t a fan of such “gimmicks,” it’s hard to deny that it makes an impression.

The Bravia 2 II isn’t a TV that’s particularly suited to gaming, and the feature list makes that clear pretty quickly. You basically only get automatic low-latency ALLM and a simple Game Bar where you can view basic signal info and change a few settings. That’s where the positives end. The TV doesn’t support VRR or 120 Hz (not even at lower resolutions) and on top of that it has problems correctly implementing HDR HGIG. It’s fine for occasional console play and, thanks to low input lag, the controls remain responsive, but if you’re after a TV primarily for gaming the Bravia 2 II is a significantly limited choice.