We also took a close look at how Blaupunkt handles colors in movie mode, and here the situation is, to put it briefly, twofold. We must clearly separate what we see in the standard SDR format from what happens when HDR is turned on, as these are two completely different worlds. Let’s start with the better side of the coin. If you plan to watch classic television, YouTube, or older movies on this TV, you can count on really well-tuned colors. In our test sample, the white balance in movie mode was exceptionally accurate, which honestly surprised us. Of course, to not make it too rosy, we noticed some flaws. Looking at the gamma charts, we observed that the processor struggles with properly dimming the image in its brightest parts. Additionally, there is quite strong, at times too aggressive, red saturation, which resulted in noticeable errors in reproducing certain shades. Nevertheless, in general terms, the image in SDR is simply solid and watchable without a grimace on your face. Unfortunately, the magic fades when we re-enter the world of HDR. Here, Blaupunkt behaves as if we suddenly switched it to store mode, and in its worst form. The excess blue in the white balance is so overwhelming that it literally clashes with the eyes, ruining any realism of the scene. Furthermore, the TV interprets brightness very loosely, which, when analyzing the EOTF curve, clearly showed that for most of the time the colors appear simply washed out and lacking depth. This is, by the way, perfectly visible in the color errors that become evident in this mode. Once again, we are left with the same conclusion: Blaupunkt in SDR mode looks significantly better and more natural than in HDR, which feels forced and not properly refined.
In Filmmaker mode our R85H sample performed adequately in SDR, but a few things immediately showed up in the measurements. In the white balance, as brightness increased more red crept in while blue decreased. As a result, the brighter parts of the image had a slightly too warm tint. On top of that, gamma only held to the target value at the start. It then gradually fell, making most of the image a bit too bright. The combination of the two also affected colors — errors grew especially in the brighter, more saturated samples. It didn’t look bad, but for Filmmaker mode we expected a bit more accuracy. Interestingly, in HDR our unit handled things noticeably better. White balance was much more even and, for most of the range, the individual RGB components stayed close together. Only in the brightest areas did red begin to fall short, causing the white point to shift slightly. The EOTF curve looked very good, tracking the target luminance values across almost the entire range. That doesn’t mean HDR colors were perfect. The ColorChecker still shows some deviations, particularly in some of the more saturated hues, but the errors are clearly smaller than in SDR.