We also took a close look at how Blaupunkt handles colours in movie mode, and here the matter is, in short, twofold. Once again, we need to clearly separate what we see in standard SDR format from what happens when HDR is turned on, as these are two entirely different worlds. Let’s start with the better side of the coin. If you plan to watch classic television, YouTube, or older films on this television, you can count on really reasonably well-tuned colours. In our test unit, the white balance in movie mode performed exceptionally well, which honestly surprised us. Of course, to avoid being overly optimistic, we did notice some shortcomings. Looking at the gamma charts, we observed that the processor struggles with appropriately dimming the image in its brightest areas. Additionally, there is quite a strong, at times excessively aggressive red saturation, which resulted in visible errors in reproducing certain shades. Nevertheless, in general terms, the image in SDR is simply solid and can be watched without a grimace on one’s face. Unfortunately, the charm disappears the moment we again enter the HDR world. Here, Blaupunkt behaves as if we suddenly switched it to shop mode, and in its worst version. The excess blue in the white balance is so significant that it is almost blinding, ruining any realism of the scene. Moreover, the television interprets brightness very loosely, which, when analysing the EOTF curve, clearly showed that for most of the time, the colours appear simply washed out and lacking in depth. This is, by the way, perfectly visible through the colour errors that become evident in this mode. Once again, we are left with the same conclusion: Blaupunkt in SDR mode looks significantly better and more natural than in HDR, which feels forced and lacking appropriate refinement.
In Filmmaker mode our R85H sample performed acceptably in SDR, but a few things stood out immediately in the measurements. In the white balance red increased with rising brightness while blue decreased. As a result the brighter parts of the picture had a slightly too warm tint. Gamma only held to the target value at the start. It then gradually fell, which left most of the image a little too bright. The combination of these two effects also showed up in the colours, with errors growing particularly in the brighter and more saturated samples. It did not look bad, but for Filmmaker mode we had expected a bit more accuracy. Interestingly, in HDR our sample fared noticeably better. The white balance was much more even and, over most of the range, the individual components stayed close together. Only in the very brightest areas did red start to be lacking, causing white to shift subtly. The EOTF curve, by contrast, looked very good and followed the target luminance levels across almost the entire range. That does not mean HDR colours were perfect. The Colour Checker still showed some deviations, especially for some of the more saturated hues, but the errors were clearly smaller than in SDR.