SONY BRAVIA 3 II (XR35M2) vs TCL P7L / P79L

The Bravia 3 II isn't exactly a TV that tries to impress with brightness. In our measurements it reached around 450 nits, so it's well short of the brightest models on the market. That doesn't mean HDR is just a paper feature here. Compared with standard SDR material, the brightest parts of the image can already punch through noticeably, and highlights, light sources and stronger exposures have a bit more energy and stand out better from the rest of the scene. You can see this best in simpler shots where the screen contains lots of bright elements. Then the Bravia 3 II can give a taste of a higher-dynamic-range picture. The problem only starts with more demanding content, where much greater brightness headroom is needed. There the TV quickly shows its limits and instead of bold, spectacular HDR we’re left with a merely competent picture.

Colours

The Bravia 3 II uses a QLED panel, although technically it doesn't employ a traditional quantum-dot layer. Instead Sony has used a PFS phosphor-based solution, which performs a very similar role: it allows for more saturated reds and greens, and thus reproduces a much wider colour gamut. In our measurements coverage of the DCI-P3 gamut was about 94%, and of the very wide BT.2020 around 74.4%. Those are good results for this class of hardware, which means the Bravia 3 II has no problem showing suitably saturated colours in HDR material. Colours don't look washed out, and the more intense hues can look really attractive.

The biggest limitation of the TCL P7L in HDR is simply brightness. The TV doesn't have much luminance headroom, so strong highlights, sunlight or small light sources can't clearly "pop" out of the image. As a result, even well-produced HDR material looks fairly restrained and, in terms of dynamics, is closer to good SDR than to what brighter models show. That doesn't mean the P7L completely fails at HDR; the issue is mainly a lack of sufficient backlight power. Looking at colours, the situation is a bit better. The TV covers roughly 91% of the DCI‑P3 gamut and about 68% of the wide BT.2020 space, so for its price class the colour range is quite decent. TCL markets this model as QLED, although the nature of the solution used is closer to a PFS phosphor‑based backlight than a classic quantum dot layer. What matters most to the viewer is the effect: more saturated colours are on offer.

In Professional mode the Bravia 3 II delivers a fairly good level of colour reproduction straight out of the box. In SDR the most noticeable issue is a slightly low gamma, which makes the midtones a little brighter. The white balance isn't perfect either; as brightness increases a bit of blue and red drops away, so whites can sometimes appear a touch warmer with a faint greenish tint. These aren't mistakes that immediately jump out when watching a film. Average error values hover around 3, so the factory setup can be considered quite good. The situation in HDR is similar. Here too there's a slight lack of blue, so the picture is marginally warmer than the reference, but the difference isn't large enough to be distracting during normal viewing.

In Film mode the TCL P7L performs quite decently without major tweaks, especially with ordinary SDR material. The white balance is relatively even, although as brightness increases there’s a slight rise in red and blue and a bit too little green. That doesn’t create a strongly visible colour cast and most colours remain close to their reference points. The Colour Checker confirms this, with a large portion of errors falling below the level that should particularly bother during normal viewing. We have more remarks about the gamma response. In the darkest parts of the image the TV drives it noticeably above the reference, so some shadow detail may be a little too dim. The curve then settles and for much of the range it’s close to the intended targets. As a result SDR generally looks natural, but in dark scenes the P7L can lose some subtlety.

In HDR the factory setup is less precise. As brightness increases the excess blue becomes more pronounced, so the picture can look cooler than it should. The number of larger colour deviations also rises, especially in brighter colours. The EOTF curve itself is handled fairly conservatively, with the TV showing the image darker than the reference over much of the range. For such an inexpensive model, the factory Film mode settings are not bad.

After calibration you can get a lot out of SDR material. The white balance was set almost perfectly, gamma practically matches the reference value, and average colour errors fell from around 3 to about 1. That’s already the level at which differences from the reference image are very hard to spot in practice. The Bravia 3 II therefore shows that despite its place in Sony’s range it has quite a bit of potential for precise picture tuning. Improvement is also visible in HDR, although here you can’t avoid all the limitations of the TV itself. Once the colours are evened out it’s easier to notice that the EOTF curve in film material runs slightly below the reference value in places, meaning the Bravia 3 II gently darkens parts of the image. That isn’t ideal from a reference point of view, but in this particular TV it also has an advantage. With no local dimming and average black levels this behaviour slightly reduces the visibility of the backlight in darker scenes and helps preserve a stronger sense of contrast. You could say Sony is partly masking the limitations of the panel this way, rather than trying at all costs to stick to the reference brightness.

After calibration the TCL P7L can produce a genuinely pleasant picture, especially with conventional SDR material. We managed to even out the white balance very well, and the gamma curve now tracks close to the target value of 2.4. This is also evident in the colour measurements, as most errors have fallen significantly and in everyday viewing it’s hard to notice any major inaccuracies. Films, series, YouTube and regular TV therefore look more natural, without unnecessary warmth or a cool tint. For a model at this price point the SDR result is really very good.

In HDR the situation becomes more complicated. Calibration improved the white balance and corrected some deviations, but here the panel’s limitations become increasingly apparent. The P7L has relatively limited brightness and can’t sustain appropriate luminance for more saturated colours, so some errors remain even after careful tuning. In other words, settings can improve how the TV interprets the signal, but you can’t overcome its physical capabilities. That’s why calibration is most worthwhile for SDR on this model.

Bravia 3 II is Sony's first TV to use the new MediaTek Pentonic 800 chip, and you can see a few changes in the image processing. Starting with the basics: the upscaling itself is decent. The TV can sensibly upscale lower-resolution material and doesn't have a strong tendency to over‑emphasise jagged edges or other source imperfections. With regular broadcast TV or lower-quality streaming material the picture therefore remains quite attractive.

We have more reservations about the digital image processing. In this model Sony has replaced the well-known "Smooth Gradation" function with a new setting called "Digital Noise Reduction". Its job is basically the same: to smooth out ugly tonal transitions and artifacts caused by heavy compression. Unfortunately, this function performs noticeably worse than before. At the "Large" setting (the only one that had any visible effect) the TV can smooth away too many image elements at once, which causes film grain to disappear and object textures or even skin to start looking unnatural. Worse still, the effect is not particularly stable. When there's more motion in a scene, the function's effect noticeably weakens and at times it looks as if the TV stops intervening in the image altogether. So for everyday viewing we wouldn't recommend using it at a high level. It can help on static shots, but the trade-off is often too much loss of detail.

In this respect the TCL P7L performs surprisingly well, especially for such an inexpensive TV. The banding reduction feature, which in many budget models does little or nothing, actually manages to improve the picture here. It doesn't remove all banding completely, but it can noticeably reduce posterisation and make trickier gradients look more natural. In this price segment that's a genuinely pleasant surprise.

The upscaling itself also looks good. Lower-resolution material is upscaled properly, without excessive sharpening or adding artificial edges around objects. Of course the P7L won't turn a very poor source into a 4K-quality picture, but for regular TV the result is simply solid. For a model at this price point there are few major complaints to make.

Motion handling is definitely one of the Bravia 3 II's strongest points. The TV uses a 120 Hz VA panel, a solution that by nature, despite the high refresh rate, doesn't always cope well with motion blur. Sony has, however, managed that issue very well here. Fast-moving objects remain sharp, and the characteristic motion trails and blur are reduced to a very low level, if not to zero. It's one of the least motion-blur-prone LCD TVs we've had the chance to test. Interestingly, in this respect the Bravia 3 II can even outperform the much more expensive flagship True RGB series, the Bravia 9 II.

TCL P7L uses a native 60 Hz panel at 4K resolution, and that's how it should be treated in everyday use. For movies the TV mainly offers frame interpolation, so it can smooth motion and reduce noticeable judder, but it doesn't deliver the smoothness typical of true 120 Hz panels.

The Sony Bravia 3 II is a very good TV for gamers, although not everything has been solved the way we’d like. The biggest change concerns the connectors. For the first time in a Sony TV we get four full HDMI 2.1 ports with 48 Gb/s bandwidth, thanks to the new MediaTek Pentonic 800 chipset. That removes one of the problems that has hung over this manufacturer’s TVs for years. You can connect several devices at once and on each input use the device’s full capabilities, including VRR and ALLM. There’s also a simple Game Bar that lets you check the key signal parameters and change a few useful settings, such as black level, when you want to improve visibility in darker parts of a game.

There are, however, two limitations worth knowing. The first is the lack of support for 1440p at 120 Hz. That won’t be an issue for everyone, but people using that resolution on a console or PC—for example to get higher frame rates in certain games—will have to choose 1080p. We have more reservations about HGiG support. Sony doesn’t let you disable tone mapping on the Bravia 3 II, so the TV keeps processing HDR even when you’d prefer to leave that task to the console. It’s easiest to spot during HDR setup—the checkerboard test pattern doesn’t disappear at the point where it should based on the TV’s actual capabilities. That doesn’t mean HDR in games will look bad. You just need to set up a little differently and, rather than relying on the pattern, manually set the peak brightness to about 450 nits. So the issue can be worked around, but you should know about it before you start configuring your console.

For such an inexpensive TV, the P7L has quite a lot to offer gamers. It has ALLM, VRR and Dolby Vision in games, and TCL also includes its Game Bar, where you can quickly check key information or change some settings without leaving the game. Not everything is perfect, though, because HGiG doesn't work here as it should, but at this price point it's hard to complain much about the feature set. The most interesting part comes when you give up 4K. At that resolution the TV runs at up to 60 Hz, but at 1440p and 1080p it can already display at 120 Hz. And that's not just a spec-sheet curiosity. In fast-paced games that support that frame rate the difference in smoothness is genuinely noticeable, so if you care more about smoother motion than maximum image sharpness, that mode can make a lot of sense. Of course, that doesn't make the P7L a true 120 Hz TV. Still, it's precisely these extra modes that make the P7L perform really well for gaming.