Samsung DU7192 (VA) vs LG OLED B6

On the luminance charts, the peak brightness of the television is around 280 nits. Unfortunately, such a value is too low to fully enjoy the effects of HDR, which require significantly higher luminance. In the tested materials, such as The Meg or Gemini Man, the lack of adequate brightness severely limits the magic of HDR, and details in the brighter parts of the image are not sufficiently highlighted. For users primarily consuming SDR content, this quality level might be acceptable but it is definitely not enough when it comes to HDR. Additionally, a DCI-P3 colour gamut coverage of 82% does not favour presenting HDR content in its full glory. The limited colour range makes it difficult for the television to reproduce vibrant and diverse hues, which is crucial for achieving a cinematic experience.

LG B6 is a moderately bright OLED. After calibration it reaches around 800 nits, roughly 200 nits more than last year's B5. That's down to LG Display's new budget OLED SE panel. In practice this simply provides a bit more headroom and makes HDR look fuller in many scenes than on last year's lower-end OLEDs. That doesn't mean the B6 has no limitations. In very bright shots, when a large part of the screen is brightly lit, brightness can fall below 400 nits. This behaviour is typical of OLED TVs (especially in this segment), and it's then you see the biggest difference compared with pricier models. All the same, we rate the B6's results as really solid. It's still not a TV built to break brightness records, but the HDR effect is strong enough that films really feel like a step up from ordinary SDR picture.

Colour gamut

Using the OLED SE panel has had some impact on wide colour-gamut coverage. Compared with last year's model the figures have dropped by a few percentage points. DCI-P3 reaches about 96%, and BT.2020 around 71%. That doesn't mean the colours on the LG B6 are weak. In most films and TV series they look vivid, well saturated and simply pleasing to the eye. You only notice the difference in very bright, highly colourful scenes. Then colours lose some intensity compared with QD-OLED panels. This is due to the WOLED panel structure. In addition to the red, green and blue subpixels it also uses a white subpixel that helps boost brightness. This comes at a cost: at very high luminance some of the colour is effectively 'diluted' by the white light, so saturation of some hues can be slightly lower. Day-to-day it's not a big problem, but you can see it in the most demanding scenes.

The best factory mode we relied on during testing turned out to be "Filmmaker." Although it is the mode that most closely aligns with the creators' intent, it still has some imperfections. In the white balance graph for both SDR and HDR, there is a clear dominance of red, resulting in significant yellowing, particularly noticeable in whites and on actors' faces. In HDR mode, there is also a slight dominance of green, which, however, does not have as large an impact on the perception of the image. The gamma, responsible for brightness in SDR materials, performed quite well, but with one serious reservation. In the darkest parts of the image, it was too low, causing excessive brightening of those scenes, depriving the film of drama and contrast. In the case of HDR, the white balance remains at a similar level, but the EOTF curve graph draws attention. At the beginning, the curve noticeably bulges, leading to strong brightening of the darkest scenes. Then, the result sharply drops below the reference line, resulting in an overly dark image and a loss of dynamics in the brighter parts.

In summary, the "Filmmaker" mode, despite its advantages, needs refinement—especially regarding white balance and proper management of brightness in the darkest and brightest parts of the image. In its current form, it may be acceptable for less demanding users, but for viewers expecting precise image reproduction, it may leave much to be desired.

We tested the LG B6 in Filmmaker Mode, the best picture setting available straight out of the box. ISF modes give very similar results, but in our tests we always stick to Filmmaker Mode for better comparison with other TVs. Each of them is a far better starting point than Vivid or Eco, where the picture is heavily boosted and noticeably less natural. For SDR content the factory settings perform really well. Colour errors are small, gamma behaves correctly, and the picture looks natural during regular viewing and does not seem overly enhanced.

It's a bit worse with HDR. Once you start playing that kind of content it's quickly apparent the white balance isn't perfectly set. Too much blue and red makes the image take on a slightly pink tint. Colour gamut measurements and the ColorChecker confirm this, with samples clearly shifting in that direction. It's not a defect that completely ruins the picture, but you can notice it with HDR films. So anyone who wants the most faithful image should consider calibration, which we cover later in the review.

Even with its lower models, Samsung offers advanced image calibration tools, which allow for significant improvement of factory settings. We took on this task, and the results turned out to be more than satisfactory. The white balance, which previously exhibited a strong yellow tint in both SDR and HDR, has been significantly improved. Although minor deviations from the norm can be observed, the overall effect is much cleaner and more natural than before calibration. As a result, whites and skin tones look much better. We were also able to properly model the gamma in SDR content, allowing for maximum contrast that this television can offer. The EOTF curve, responsible for HDR content, has also been improved – the image is no longer brightened or darkened as drastically as it was before calibration. Despite these successes, HDR content still struggles with high deltaE error values. The main reason lies in the limited brightness of the television, which does not allow for a full representation of the dynamics of HDR content. Nonetheless, after calibration, the image is clearly better and much closer to the creators' intent. For users seeking the best possible quality in this class of equipment, calibration is definitely recommended.

During calibration we focused mainly on HDR material, because that’s where the factory settings needed the most correction. We didn’t neglect SDR, though. After tuning it was brought almost to perfection. Colours are very accurate and brightness is controlled as it should be. The biggest change in HDR came from improving the white balance. After removing excess red and blue the pinkish tint disappeared and the image became much more natural. Skin tones, whites and all colours that had previously leaned towards pink improved. After calibration most errors fell below Delta E 2-3, the threshold at which an average viewer stops noticing differences with the naked eye. So the LG B6 can produce a very accurate picture, especially for the manufacturer’s entry-level OLED model.

The tonal transition smoothing feature works in two modes – 'off' and 'auto'. Turning it off causes gradation issues, while the 'auto' mode provides smooth transitions, but at the cost of grain effect and details, which are often blurred. Due to these limitations, we do not recommend using this feature, as confirmed by our tests conducted with it turned off.

Scaling lower resolution materials in this model is not impressive. Details are blurry, and the edges of objects may contain artifacts. This limitation means the television performs better with higher resolution content.

LG B6 copes very well with lower-quality material. Much of that is down to effective digital image processing, which can mask some source imperfections without excessively smoothing the whole scene. The "Smooth Gradation" feature proves particularly useful. It lets you noticeably reduce posterization mentioned earlier, especially in dark parts of the image. The safest choice is to set it to Low or Medium. The feature still effectively smooths out harsh tonal transitions, but doesn't yet interfere too much with fine details. Die-hard purists can of course leave it off. Upscaling to 4K also performs very well. Full HD and 720p content retain a fair amount of detail, and the image is neither overly sharpened nor heavily blurred. Some limitations are only noticeable with very poor sources below 720p, where the smallest text and fine elements aren't always perfectly sharp, but this is true for almost every other TV on the market.

Even though Samsung DU7192 is the lowest model in the manufacturer's range, it is equipped with a motion smoothing system. While the functionality of this solution is significantly limited compared to more expensive models, its mere presence makes the TV stand out against the competition in this price bracket. The TV supports a maximum refresh rate of 60 Hz, which is sufficient for comfortable viewing of movies and series, but may be inadequate for dynamic content such as sport. In the motion smoothing menu, we find, among other things, a "Vibration Reduction" feature. Unfortunately, its performance leaves much to be desired – regardless of the setting, the image retains the characteristic stutter known from material recorded at 24 frames per second, which means that this feature practically fails to fulfil its purpose.

One of the biggest advantages of OLED panels is their very fast pixel response time. That keeps the picture sharp and prevents visible smearing that often appears on LCD TVs. It does have a downside, though. During slow camera pans motion can look a bit choppier than on LCD screens, where the slower panel naturally masks some of that effect. Fortunately, on the LG B6 this is easy to tame with TruMotion. With the motion smoothing set correctly you can get smoother motion without giving the picture an exaggerated soap-opera effect.

Samsung DU7192 is equipped with HDMI 2.0 ports, which is expected at this price range. This limitation means there is no support for the full capabilities of the latest generation consoles, such as VRR technology. The TV offers only basic features for gamers – automatic switching to low-latency mode (ALLM), and support for basic HDR for games in HGiG standard. HGiG allows for displaying HDR content in games according to manufacturers' guidelines, however, the limited brightness of the TV does not allow full enjoyment of the effects that this standard offers. Unfortunately, there are no conveniences such as GameBar, which is increasingly common even in cheaper models and significantly facilitates quick adjustment of settings for games. The presence of this feature could significantly enhance the user experience, especially for those who frequently switch display modes.

LG OLED B6 has plenty going for gamers; it's a complete base for the PS5, Xbox Series X/S or a solid PC. It comes with four full-size HDMI 2.1 ports with 48 Gb/s bandwidth, so you can forget about annoying cable swapping when you want to connect several newer devices at once. We get a full package of sync technologies, from classic VRR to G-Sync and FreeSync. The panel effortlessly syncs its refresh rate to the frame pacing produced by your console or graphics card. Of course ALLM is present: the B6 automatically recognises when a game is running and immediately cuts latency to a minimum. HDR support is also excellent. The TV supports Dolby Vision, and a correctly implemented HGiG means that after an initial calibration in the console settings the picture won't suffer from blown-out whites or lost detail in bright areas. The icing on the cake is the Game Bar. Instead of digging through the full menu mid-game, a single click lets you correct shadow visibility, tweak chosen parameters or simply check the display's current mode. All of this makes the LG B6 a great choice for gamers.