We also took a close look at how Blaupunkt handles colours in movie mode, and here the matter is, to put it simply, twofold. We must once again clearly separate what we see in the standard SDR format from what happens when HDR is switched on, as they are two completely different worlds. Let's start with the better side of the coin. If you're planning to watch traditional TV, YouTube, or older films on this television, you can count on really well-tuned colours. In our test sample, the white balance in movie mode performed exceptionally well, which honestly surprised us. Of course, to avoid being too rosy, we noticed some drawbacks. Looking at the gamma charts, we observed that the processor struggles with properly dimming the image in its brightest areas. Additionally, there is quite a strong, at times overly aggressive, red saturation, which resulted in visible errors in reproducing certain shades. Despite this, overall, the image in SDR is simply solid and watchable without a grimace on your face. Unfortunately, the magic fades when we re-enter the world of HDR. Here, Blaupunkt behaves as if we suddenly switched it to store mode, and in its worst rendition. The excess blue in the white balance is so significant that it’s glaring, ruining any realism in the scene. Furthermore, the television interprets brightness very loosely, which, upon analysing the EOTF curve, clearly showed that for most of the time, colours simply appear washed out and lacking depth. This is also perfectly evident in the colour errors that become apparent in this mode. Once again, we are left with the same conclusion: Blaupunkt in SDR mode looks significantly better and more natural than in HDR, which seems to be forcefully added without proper refinement.
In Filmmaker mode our R85H sample in SDR performed adequately, but a few issues immediately stood out in the measurements. In the white balance, as brightness increased more red was added while blue decreased. As a result, the brighter parts of the image had a slightly too-warm tint. Gamma only held the target value at the start. It then gradually fell, which left most of the image a little too bright. The combination of these two factors also affected the colours, with errors growing particularly in the brighter and more saturated samples. It did not look bad, but for Filmmaker mode we expected a bit more accuracy. Interestingly, our sample fared noticeably better in HDR. The white balance was much more even and the individual components stayed close to one another across most of the range. Only in the brightest parts did red start to be lacking, causing white to shift subtly. The EOTF curve looked very good, tracking the target luminance across almost the entire range. That does not mean HDR colours were perfect. The Colour Checker still shows some deviations, especially for some of the more saturated colours, but the errors are clearly smaller than in SDR.